MagikFingerz wrote:This is just a theoretical design, so there might be things I haven't anticipated for actually building it. Which I will probably never be able to do, since I'm much more theoretical than practical But let me know what you think.
Very rough MS Paint sketch below. The uncuts need to be between relatively thin sheets of plexiglass or similar, with thin frames.
A is a hollow wooden "shell" made to house the uncuts not on display. This will ideally match the walls of the room.
B (red dot) is the hinge which all the uncuts rotate on.
C is the uncut currently on display. Haven't quite figured out how best to fasten this.
D (grey square) is the uncuts not on display, housed in A. Unsure of how many could be held here, too many would mean A needs to be unaesthetically big and perhaps place too much weight on B.
E shows a removable top part of A, which will make it look more aesthetic when on and allow the uncuts to be rotated up and down when off.
Users browsing this forum: dazzleguts and 1 guest